I have installed in the Seneca V of Carenado, the system of lights A2A Redux. In the .cgf file of the airplane I only have three types of lights. The others, like landing lights or taxis do not appear in the .cfg file. I was able to locate the .mdl file on the plane and open it with the ModelconverterX program. What I would like is to know how to locate the coordinates of these lights with this program, to be able to put A2A Redux, properly in place.

 

Didn't the A2A Redux light effects come with any installation instructions for your particular Seneca V?

 

I found this for adding them to a Seneca twin.

 

[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing, 6=taxi,
light.0 = 3, -5.15, -18.75, 1.16, fx_navredcarenpa34
light.1 = 3, -5.15, 18.75, 1.12, fx_navgrecarenpa34
light.2 = 10, -4.0, 0, 1.90, fx_vclightpa34
light.3 = 10, -8.25, 0, 1.80, fx_vclightpa342
light.4 = 2, -5.30, -18.75, 1.16, fx_shockwave_strobe_sm_2_nl
light.5 = 2, -5.30, 18.75, 1.12, fx_shockwave_strobe_sm_3_nl
light.6 = 8, -3.65, -16.10, 2.145, fx_icelight_pa34
light.7 = 2, -21.20, 0.05, 6.35, fx_shockwave_beacon_fastflash_lowl
light.8 = 5, 1.6, 0.2, -1.50, fx_shockwave_landing_light_small_old
light.9 = 6, 1.6, -0.2, -1.50, fx_shockwave_landing_light_low_old

Add this to your vcockpit01
gaugexx=shockwave_lights!SW Lights_gear, 1,1,1,1 //shockwave light
gaugexx=shockwave_lights!SW Lights_taxi_gear, 1,1,1,1 //shockwave light

xx being the next gauge

No, it does not bring instructions for this particular model. It is the Seneca Carenado V. The landing lights are at both ends of the wings

I know this will look a little funky.   I used a freeware Seneca II and added Shockwave landing lights to the wing-

tip areas.  This is what you will have to do.  You are basically overlaying the A2A Redux lights over the light effects the

Mfgr. used.