VFR Touch and Go's

[RodgerC 58]

Every once and a while, I like just doing touch and goes at a single airport.  Now that I have MCE and PF3 I want to include ATC.  How can I do this?  PF3 demands at least one waypoint in order to use ATC.  I was going to use MCE and FSX ATC, but got a message that PF3 was not connected and MCE copilot could not bring up FSX ATC.  I'm sure I'm just doing something wrong.  Can someone point me in the right direction?  Thanks

Rodger

[FS++ 708]

11 hours ago, C130FE said:

Every once and a while, I like just doing touch and goes at a single airport.  Now that I have MCE and PF3 I want to include ATC.  How can I do this?  PF3 demands at least one waypoint in order to use ATC.  I was going to use MCE and FSX ATC, but got a message that PF3 was not connected and MCE copilot could not bring up FSX ATC.  I'm sure I'm just doing something wrong.  Can someone point me in the right direction?  Thanks

Rodger

You need to switch MCE to Native ATC.

 

Go to <ATC> tab in MCE user interface and look at the bottom of the panel.

 

Use the "-" and "+" arrows to switch between ATC modes. Set it to "native ATC" and don't forget to click <Apply> then restart MCE.

 

After that you'll be on Native FSX ATC and MCE will read ATC window content and control that window as well.

.

[RodgerC 58]

3 hours ago, FS++ said:

You need to switch MCE to Native ATC.

 

Go to <ATC> tab in MCE user interface and look at the bottom of the panel.

 

Use the "-" and "+" arrows to switch between ATC modes. Set it to "native ATC" and don't forget to click <Apply> then restart MCE.

 

After that you'll be on Native FSX ATC and MCE will read ATC window content and control that window as well.

.

Thank you, still trying to learn how all this works.