747-400 Rudder is not on center

[asanal 32]

I can not coordinate 747  Rudder to be in the center position.. in VC  rudder pedals are right position.

Will you please advise, how to calibrate the rudder.

 

IN my test flight right rudder pedal  more  forward  then left pedal A/P on

[Captain Kevin 586]

Going to need a lot more information than that. If you're using any hardware, is THAT calibrated.

[asanal 32]

Hi Kevin,

I have CH Eclipse yoke and Pro Pedals.

Last week  ,Dell re installed  Window 10 . With fresh start . I reinstalled P3D 747,777 and 737.

 installations completed with out any  incident. Test fly with ,777,737 were  normal. Next day  I loaded  747,but  controls started   shaking continuously (Not in VC view)  I thought it can be "Calibration" problem. I cannot located CH-Control Manager I called the  manufacturer, downloaded CH manager software. 

I uninstalled\reinstalled 747 but this time VC panels was black. I realized it can be a some  kind activation problem, but there were no   "activation code" request . 

 I tried to open ticket, as you know,my  e-mail address didn't realized by PMDG Support. I used my secondary e-mail address  and registered  an new account"  

I re checked 777 and 737.They were OK without any activation issues.

I decided to uninstall and reinstall 747. After re installation completed, I started P3d  and 747 appeared with out black screen (NO activation code request)  and no control shaking, but rudder was not in center. 

This is  my  story.

 

Follow up:

I just checked several times:

737,747,777 Rudders are not in Center

 

 

 

[asanal 32]

Good news.

I solved the problem, after spending many hours.

(Actually it was simple, after stabilizing all controls).

Open Settings>controls change "Control Type" to Rudder Pedals> Rudder Axis and at  Null Zone reduce value from 36 to 1.