Beaver - Installation DLL.XML error message

[andyb_1972 5]

Hi,

Not sure if this error is anything to worry about? Apart from this message, the installation appeared to go perfectly normally and the Beaver looks fine in the sim. Haven't flown it much yet though.

Thanks in advance,

Andy

[spesimen 135]

i'm pretty sure that's important, some of the systems may not work correctly without the xmltools dll running, at least based on some posts i skimmed on their support forum.

i don't know how to suggest fixing it but i'd definitely advise posting on their forum or searching around a bit on there.. may already be a more precise answer posted..

good luck!

cheers,-andy crosby

[Katoun 30]

This issue is resolved on our forum - for registration send your details to oisin[at]milviz[dot]com

[andyb_1972 5]

Thanks guys, I will register and check out the Milviz forums. All the best.

Andy

[Zigarten 6]

On 6/4/2017 at 8:41 AM, Katoun said:

This issue is resolved on our forum - for registration send your details to oisin[at]milviz[dot]com

Where? I'm searching..too many hits...

[Milviz 919]

you will need to have access to the support forums.  There's only about 2 requests for help on this particular issue.

[Zigarten 6]

On 2017-11-29 at 4:34 PM, Milviz said:

you will need to have access to the support forums.  There's only about 2 requests for help on this particular issue.

I must be blind. What’s the title on the posting list over there?

[Milviz 919]

You'll need to get access to the support forums.  Page one of the manual will explain how...

[n4gix 4,947]

On ‎12‎/‎29‎/‎2017 at 9:13 AM, Zigarten said:

I must be blind. What’s the title on the posting list over there?

Gauge [XMLTools]

[Zigarten 6]

On 12/29/2017 at 4:07 PM, Milviz said:

You'll need to get access to the support forums.  Page one of the manual will explain how...

I'm already on there, I just don't see the post that is being referenced here.

[Katoun 30]

it's the topmost sticky
Gauge [XMLTools]

[Zigarten 6]

This is getting ridiculous, I logged in, came back here, clicked on that link and I get

 

You are not authorised to read this forum.

[sic] not my spelling....

 

 

 

 

[Katoun 30]

Not sure what the problem is - maybe you are not registered for the support forum?

PM (or email) me and I'll sort it out.

[Zigarten 6]

Yeah, I think I may not be for the "Beaver". I just assumed it's an all access pass once activated. Message sent!

 

Thanks!

Gord