As2016/ASCA for P3Dv4 beta #2 Available

[Drumcode 1,892]

1 hour ago, SKEWR said:

I like that if you check under conditions page, you can see runways in use.... Cool feature

Where? Looking and can't see.

[ZKOKQ 984]

2 hours ago, beachdog2001 said:

My install seemed to go without a hitch. What indication did you get that something went wrong?

For some reason, it created 3 paths to P3Dv3. Hifi said this may happen to some users. I was one of them :)

[RudiJG1 172]

20 minutes ago, Drumcode said:

Where? Looking and can't see.

Enable airports in the AS16 map and hold your mouse over it. You'll see a pop-up METAR with the runway(s) in use right under the METAR string at the top of the pop-up.. This is documented in the manual...

[blackbird7 3]

55 minutes ago, Travelling_Wilbury said:

For some reason, it created 3 paths to P3Dv3. Hifi said this may happen to some users. I was one of them :)

Yep, this happened to me, too.  I essentially had two P3Dv3 paths instead of separate paths for v3 and v4.  I clicked the "Reset Simulator Definitions" button, and this seemed to fix things for me.  If I experience any problems, I'll try your fix and delete the config file.  

[ZKOKQ 984]

1 minute ago, blackbird7 said:

Yep, this happened to me, too.  I essentially had two P3Dv3 paths instead of separate paths for v3 and v4.  I clicked the "Reset Simulator Definitions" button, and this seemed to fix things for me.  If I experience any problems, I'll try your fix and delete the config file.  

Darn, I did not notice that button :)

[captain420 3,099]

Thanks for sharing the runway in use feature, I didn't know about that!

[SKEWR 364]

You can also see it on the "Conditions" page near the bottom. It appears over "Forecast Hours" at the bottom of that page.

[reecemj 143]

Runway in use also in the flight briefing.