Justsim ELLX showing default scenery

[armchair_pilot 54]

Hello, I just purchased ELLX scenery from Justsim and installed it for P3Dv3.4. I noticed that the scenery is showing alongside with some default buildings. I checked for duplicate AFCADs but there are none. During installation I turned off my antivirus and ran the installer as admin. What else could cause this?

[GSalden 4,652]

Did you ask Justsim support about it ?

[armchair_pilot 54]

I've hoped to get an answer on this forum but will post it on their facebook page, thanks.

[Farlis 2,277]

Whatever you are seeing there has nothing to do with their product. It is your specific setup. I have the scenery installed as well, and I see no default buildings.

Best way to troubleshoot is to switch off all your other add-ons and run the scenery just with the default setup.

[armchair_pilot 54]

Found out that it's MyTraffic 6 interfering with the scenery. There were a few BGLs that I did not see in the MyTraffic folder and now they're disabled so everything's fine now.

[Indy511 686]

 

19 minutes ago, armchair_pilot said:

Found out that it's MyTraffic 6 interfering with the scenery. There were a few BGLs that I did not see in the MyTraffic folder and now they're disabled so everything's fine now.

Glad you got it sorted out.

[cmpbellsjc 2,960]

On 6/19/2017 at 1:14 PM, armchair_pilot said:

I checked for duplicate AFCADs but there are none.

 

1 hour ago, armchair_pilot said:

Found out that it's MyTraffic 6 interfering with the scenery. There were a few BGLs that I did not see in the MyTraffic folder and now they're disabled so everything's fine now.

99% of the time it's a duplicate AFCAD. If only I had a dollar for every time a post was made for this issue, I'd be loaded.

Unfortunately since MTX installs tons of AFCADs it's caused people this frustration for years trying to figure out why they have default building showing through payware scenery.

Best thing to do is get the freeware AFACD scanner for ScruffyDuck and run it once in a while after installing new stuff to make sure you don't have dips. It will find them, give you the location, then you can't either remove them or rename the file extension from .bgl to .off in case you need to use that AFCAD again in the future.

[armchair_pilot 54]

1 hour ago, cmpbellsjc said:

 

99% of the time it's a duplicate AFCAD. If only I had a dollar for every time a post was made for this issue, I'd be loaded.

Unfortunately since MTX installs tons of AFCADs it's caused people this frustration for years trying to figure out why they have default building showing through payware scenery.

Best thing to do is get the freeware AFACD scanner for ScruffyDuck and run it once in a while after installing new stuff to make sure you don't have dips. It will find them, give you the location, then you can't either remove them or rename the file extension from .bgl to .off in case you need to use that AFCAD again in the future.

Thing is I used that scanner and it did not find those files, mainly because they are not duplicates. It cannot be FTX Global since no one else seems to be having the same issue. I've never installed another scenery for ELLX in P3D, quite strange