Using add-on Scenery over Photo real (

[dlm9000 10]

I use both ORBX FTX line of products and Austria Pro HD.I switch back and forth depending on the flying I am doing, and I like both.  When using the ORBX Freeware Airport (LOGO) with Austria Pro HD, the underlying photoreal scenery shows in the airport area that is not tarmac.  The alignment of the two products does not match that well, so the imagery of buildings and runway are where grass would normally be.  Is there a way to prevent the photoreal imagery from showing in the airport scenery and just use the ground textures? maybe some sort of mask?  I am new to photoreal, 

Dennis

[Clutch Cargo 384]

You could try going through the scenery folder of the add-on and temporarily de-activate them by renaming them.  It's a hit-n-miss if it will work.  Just look for the largest size files.  Those are usually the photoreal files.

[HighBypass 2,339]

I'm assuming that you've got the scenery priority set - photoreal lower than the add-on airport?

I believe Scruffyduck's Airport Design Editor (ADE) can create a mask which overlays any scenery below the airport.

Is there any support from ORBX despite the airport being freeware?