Flight1 GTN 750 keyboard assignment?

[newtie 533]

Hi all-

Can the GTN 750 GPS window be assigned a keyboard sequence to open and close vs clicking on the stack? I wouldn't mind substituting Shift + 2 to it instead of the stock GPS but don't know how to do it.

Cheers,

Mark

[vgbaron 3,616]

Yes. depends on which aircraft. Look in the panel.cfg file near the top. The "clickable" windows are usually listed. Whatever number is assigned to the GTN - use the next higher. So if panel says Window 06 = f1 gtn 750 etc..... you would use shift 7 to open the window.

Vic

[newtie 533]

Hi Vic-

It's the XtremePrototypes Lear. I'm not at home right now but will check it out when I get home. I think Bert had a panel cfg edit that put it into the panel but not sure.

 

Thanks,

Mark

[joepoway 241]

In my case it assigns it to spot 13 in my A2A aircraft and therefore you can't use a keyboard shortcut. However I open the panel.cfg file for each specific aircraft and swap the contents of [window 4] with [window 13] because I don't open the default P3D maps. Also at the top of the config file I change the name of Window04=GTN 750 and make Window13=Map. This allows me to assign the maps key to open and close the GTN 750 I also assign that key using Voice Attack so I can open and close it with a voice command. 

Additionally I do the same for my A2A T6 using the GTN 650

Hope this helps

Joe

[vgbaron 3,616]

Mark - Joe's method is the easiest if the window assigned is > 9. 

 

Vic

[newtie 533]

Thanks guys I'll check it out. 

Cheers,

Mark