having trouble getting Cropduster X to work

[MrDirt 7]

I recently brought Cropduster X.  I installed by the installer to work with P3DV4.  i START P3DV4 and I am using Milviz new Beaver cropduster.  I have it started and I drop out to start CDX.  CDX starts and I connect it with P3DV4.  I get nothing in the area that is suppose to give you information about the fields you are to spray.  I get a green circle that goes around and around, but nothing ever loads.  I then set it up for FSX acc and I get the same thing nothing ever loads.  What am I doing wrong.  I have used Firefighter x with my FSX install and had no problems.  Please help me figure this out and thanks in advance for the help.

John

[Lorby_SI 2,036]

Hello John,

this sounds like an installation error. Did you change the default installation path of CropDuster X, especially the one for P3D V4?

- Please check in "\Documents\CropDuster X Files ... " if there is a logfile, and if there is, please send it to me via email (address is on the last page of the documentation).

- In the off chance that there is something wrong with your scenery, please turn on "Disable surface checks" on the first page of the Settings and try again.

- Have you configured the Beaver with the CDX payload manager dialog? And did you try a different aircraft too?

Best regards