No yoke control FSUIPC 777-200

[Navigator43 25]

Trying to program my yoke with FSUIPC in the 777-200 in P3D 4.1 but it’s not working. No axis are being programmed. Yet in 4.0 all this would work fine any ideas what may be the problem?

[Ephedrin 418]

Have you accidentally deactivated your controllers in the P3D controller settings? 

[Navigator43 25]

I turned them off in P3D controller settings so I can set them with FSUIPC but it’s not working

[scandinavian13 5,192]

33 minutes ago, aushie said:

Trying to program my yoke with FSUIPC in the 777-200 in P3D 4.1 but it’s not working. No axis are being programmed. Yet in 4.0 all this would work fine any ideas what may be the problem?

This is an FSUIPC issue, and I'm willing to bet that it's a bad .ini from the earlier sim. When troubleshooting with FSUIPC, remove the ini first. Usually solves it.

[Navigator43 25]

Ok will try it

[Ephedrin 418]

When you turn them off (untick controllers in general) in te p3d controller settings you can‘t use them via fsuipc either... delete the axes but activate the controllers.

[Navigator43 25]

3 minutes ago, Ephedrin said:

When you turn them off (untick controllers in general) in te p3d controller settings you can‘t use them via fsuipc either... delete the axes but activate the controllers.

They are ticked 

[Ephedrin 418]

Ok then it smells like an ini thing ^^

[Navigator43 25]

20 minutes ago, Ephedrin said:

Ok then it smells like an ini thing ^^

Trying that issue now thanks

[Navigator43 25]

Can’t get it too work I tried a clean install the whole nine yards and no good. Must be an FSUIPC issue. The 737 works fine apart from trying to program the spoilers axis 

[Ephedrin 418]

Can you explain what exactly you are doing in FSUIPC? Maybe it‘s just something little you miss? 

Do you use „send to FS“ or fsuipc calibration?

[Navigator43 25]

Send to FS 

[Navigator43 25]

Maybe my firewall is interfering or something

[Navigator43 25]

Bottom line is FSUIPC is not working right with my PMDG aircraft I’m going to go complain to Pete 

[Navigator43 25]

I figured it out it was send to FS calibration I wasn’t doing that