Mixture controls drop to zero

[johnbla 31]

Hi all

All of a sudden I have this problem where my mixture controls drop to zero and the engines cut out. As soon as I raise the mixture controls, the engines re start. The only problem is that it happens every few minutes. It happens if I have automixture ticked and unticked.

I have even reinstalled P3D from scratch and it is still happening, so I am at a loss and pulling my hair out.

I have checked my assignments and don't think I have a conflict. i have no failures ticked. I have turned on carb heat.

If anyone has any ideas on how to fix it, I would greatly appreciate it.

Many thanks.

John

[Boeing100 3]

Did you maybe accidentally assign the mixture control axis to one of your throttle/joystick axes?

[johnbla 31]

Thanks Boeing, no it's not that. It even happens when i don't have the joystick plugged in.