Recommended Posts

I am having the weirdest of problems with vPilot (and also EuroScope when observing). The sound/comms randomly stops working until press the transmit button. It is as if vPilot loses connection with the network but is then resolved immediately when I press send.

This happens in vPilot and also in EuroScope, but no other software.

I have wondered if this is related to my sound setup (using VoiceMeeter with virtual sound devices), but then I believe I should have noticed this with other software as well - especially communications software.

This is driving me insane, and it has caused trouble for me on numerous occasions (not following ATC commands, because, surprise, I can't hear them). This is especially noticeable in airspace that has low traffic, since the delay between comms may be longer, and it's impossible for me to tell if there has been a transmission or if it is just quiet...

Any help is appreciated. vPilot is run as administrator, and so is P3D.

Share this post

Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

I am having the exact same issue. Began happening in the last few weeks. I have not found the cause. Any help appreciated. 

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now