RealAir Duke Turbine V2 P3Dv4 HSI question

[vonmar 122]

RealAir Duke Turbine V2 P3Dv4 HSI question

I installed the RealAir Duke Turbine V2 into P3Dv4 using the current installer (thank you Sean Moloney).
The installation went without any errors.
I am using the F1 GTN750 in the VC panel.

During a test flight I noticed the HSI deviation needle is locked at the far left max CDI deviation position when in GPS  NAV mode (screenshot).
Note : the HSI in the FSX and P3Dv3 versions are deflecting properly.

I just want to verify it is correct for the P3Dv4 installation.

https://imgur.com/a/56Y9x

 

[Bert Pieke 7,584]

As you have also noticed, you have a red flag showing in the HSI, which would mean no valid CDI signal is received. 

[vonmar 122]

Yes, I was just reporting the problem and wondered if other pilots were also seeing it or not.

[ryanbatc 12,820]

So you're sure the GTN is driving the HSI?  I.e. Flight1 config app setup properly?  Perhaps an ini setting was changed.

[vonmar 122]

12 minutes ago, ryanbatcund said:

So you're sure the GTN is driving the HSI?  I.e. Flight1 config app setup properly?  Perhaps an ini setting was changed.

Ryan,

Since my initial post here I seen problems with the RealAirDuke V2 and the Alabeo PA44 and the follow up posts are in F1 Forum here:

Still trying to sort it out.

http://www.simforums.com/forums/f1gtn750pa44navfailerrorindicated_topic59406.html