taxi instructions for flightbeam KIAD

[BillStewart 3]

Hi again,  trying this out and noticed that the airport map  for KIAD doesn't show any taxi paths to runway 19R.   I did see however, a whole bunch of crossing green lines all over the terminals..  ATC told me to taxi to 19R via taxi ways that I don't see.  I'm using Flightbeam scenery. Am I suppose to create my own taxi routes?

Thanks

Bill

[Dave-Pilot2ATC 870]

You can use Taxi Mnt to update the taxiway and gate data.  Read the section on Taxiway Maintenance in the User's Guide.

Be sure you back up the P2ABaseData.mdf file before you start importing or making changes so you can get back to where you started if you don't like the results.

Or, better yet, do a Save of the Airport Taxiways and then rename or move the resulting file so you can Load the original taxiways back if you don't like the new results.

Then import that airport from your scenery according to the instructions and if needed, make any adjustments needed to get it to work.

Dave

[BillStewart 3]

thanks...so, is this tool mainly for add on airports in p3d/fsx?  Should I assume all default airports are working fine?

Bill

[Dave-Pilot2ATC 870]

Taxiways and Gates in default airports should work.  Generally you would only go to the trouble of using Taxi Mnt for the airports you frequent a lot.

Dave