Sign in to follow this  
Claudio Borlotti

Two Saitek Pro Yoke on same P3D v4.x

Recommended Posts

Hello everyone,
I want ask if is possible to use 2 Saitek pro yoke on the same Pc with P3D V4 because i want to simulate the Captain and First Officer position, and other question, is  possible to use the 2 throttle quadrant for mixed the control, left engine - right engine - spoilers and flaps (6 channel) ? 

Thanks for your help!
Bye
Denis

Share this post


Link to post
Help AVSIM continue to serve you!
Please donate today!

2 throttles = yes

2 yokes I’m not sure it would work, it may cause a conflict

Share this post


Link to post
Posted (edited)

2 yokes work together without conflicts if you configure them directly through FSUIPC.

But of course not work synchronously. Control will be intercepted.

Edited by Nickbe

Share this post


Link to post

Thanks a lot for your response guys, I will try to configure 😁
Best Regards.

Denis

 

 

Share this post


Link to post
2 hours ago, Nickbe said:

2 yokes work together without conflicts if you configure them directly through FSUIPC.

But of course not work synchronously. Control will be intercepted.

With FSUIPC assignment, the one with the most displacement from centre will be the one used. So if the Pilot Not Flying kept his hands off, and the central zone was calibrated properly with no serious jitter, then they'd work well together. Rudders too.

Pete

 

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this