Ezdok problems

[Herr Schmidt 0]

I have a problem...

When I want to start the Ezdok config.exe I get the message "Components is registered.Restart application"

Which application do I have to restart?

[onebob 125]

Did it  also show .. 'Done' you can use the tool, if so you can close the config program down and then start the flight sim.

bob

Edited July 25, 2018 by onebob

[Herr Schmidt 0]

Hey Bob!

No it didn´t.Does it help if I reinstall it?

 

[onebob 125]

2 hours ago, Herr Schmidt said:

Hey Bob!

No it didn´t.Does it help if I reinstall it?

 

I would uninstall it and using the F1 wrapper re-install, run the config tool by right clicking and select 'run by admin' after plugging in all your usb devices.

assuming your on Prepar3D v4.3 you can also update  ezdoc v2 to 2.6.0.23 9 it may advise you on this after starting up Prepar3D.

edit ..open P3D only after the above procedure.

 

bob

 

Edited July 25, 2018 by onebob

[Nickbe 401]

50 minutes ago, onebob said:

assuming your on Prepar3D v4.3 you can also update  ezdoc v2 to 2.6.0.23 9 it may advise you on this after starting up Prepar3D.

For Prepar3D 4.3 use EZdok Camera 2.7.0.17

Download 2.7.0.17

[Nickbe 401]

7 hours ago, Herr Schmidt said:

I have a problem...

When I want to start the Ezdok config.exe I get the message "Components is registered.Restart application"

Which application do I have to restart?

You need reinstall with Flight1 wrapper EZCA 2.0, then update to 2.7.0.17

[onebob 125]

21 minutes ago, Nickbe said:

You need reinstall with Flight1 wrapper EZCA 2.0, then update to 2.7.0.17

yes that's correct, where I got that 2.6...… from . hmmm

many thanks for the correction

bob

 

edit just noticed that's the ver of the config tool.

Edited July 25, 2018 by onebob

[GEKtheReaper 364]

17 hours ago, Herr Schmidt said:

I have a problem...

When I want to start the Ezdok config.exe I get the message "Components is registered.Restart application"

Which application do I have to restart?

Mr. Schmidt,

in order to get the best help out there is to provide more informations like:

- what sim do you use (with version)?

- what version of EZDOK do you have?

- ...

As a general info for you: EZDOK places the config tool on your desktop. You should run that as an Admin (the sim should not run in this time). It will do some stuff and will end with the message "you can close tool" or something. Now you can start your sim and the camera addon will launch with it.

[Nickbe 401]

The "Components is registered.Restart application" message appears if EZCA2 has been uninstalled and one of the updates (2.7.0.10-2.7.0.17) has been installed. Updates are not a full installation of the program. Be sure to install the version 2.0 of the Flight1 installer (wrapper) when you completely reinstall EZCA2 and then install the latest update (currently 2.7.0.17)

[Herr Schmidt 0]

Thank you all for your support to my problem.I solved the Problem with reinstall it.

Herr Schmidt