can't specify BU0836A interface

[Pawel S 0]

hello!

My setup have two identical BU0836A cards to control yoke and rudder pedals. When I specify under set PTT particular one (when there is reaction to button pushed) and save. Wrong (first on the list) interface card is used and Pilot2ATC reads switch status from wrong device. When I open config again wrong BU0836A is set after window opens.

This was confirmed by pluging off second (first on the list) one. And with just one it works perfectly. 

version: 2.5.0.5_r3

best regards!

pawel

 

[Dave-Pilot2ATC 870]

If their names are not unique, then P2A will not be able to distinguish them.

If you can set the button to mimic a keystroke, then you can set the P2A HotKey instead of the Joystick button.

 

[robvanderwiele 2]

Hello Pawel,

Look at this link http://www.leobodnar.com/shop/index.php?main_page=product_info&cPath=94&products_id=204

And select the product download tab. You can download software to rename the firmware, this way the devices have different names.

Regards,
Rob

 

Edited September 12, 2018 by robvanderwiele