Jump to content
Sign in to follow this  
Pawel S

can't specify BU0836A interface

Recommended Posts


My setup have two identical BU0836A cards to control yoke and rudder pedals. When I specify under set PTT particular one (when there is reaction to button pushed) and save. Wrong (first on the list) interface card is used and Pilot2ATC reads switch status from wrong device. When I open config again wrong BU0836A is set after window opens.

This was confirmed by pluging off second (first on the list) one. And with just one it works perfectly. 


best regards!



Share this post

Link to post
Share on other sites

If their names are not unique, then P2A will not be able to distinguish them.

If you can set the button to mimic a keystroke, then you can set the P2A HotKey instead of the Joystick button.


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Tom Allensworth,
    Founder of AVSIM Online

  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Create New...