Heading Bug Not Moving On Falcon

[Wink207 78]

Getting there, step by step. Today I reached the point of taxiing to the active, ready to give it a go. However, holding short I tried to set up the AP for after departure. Well, I couldn't figure out how to set the heading bug for the active heading. Try as I may, it would not budge. I tried my yoke heading switch, clicking on the PFD and what looks like a small panel pops up but the heading bug would not move, and finally I tried the knob down on the center console labeled Heading just above the AP controls, and once again the stubborn bug would not move. Could someone please tell me where I am going wrong?

Thanks all

Rick

[ark 1,288]

46 minutes ago, Wink207 said:

Getting there, step by step. Today I reached the point of taxiing to the active, ready to give it a go. However, holding short I tried to set up the AP for after departure. Well, I couldn't figure out how to set the heading bug for the active heading. Try as I may, it would not budge. I tried my yoke heading switch, clicking on the PFD and what looks like a small panel pops up but the heading bug would not move, and finally I tried the knob down on the center console labeled Heading just above the AP controls, and once again the stubborn bug would not move. Could someone please tell me where I am going wrong?

Thanks all

Rick

Rick,

You are correct, same here, the heading bug does not work now even though it did before. Something must of happened with the latest install package. I'm sure it will get fixed in the next update.

BTW, there is no yoke heading switch (there is a trim rocker switch on the Yoke). The heading and course adjustment knobs are on the center console just above the AP. Clicking on the HSI will bring up a similar looking popup.

Al

Edited November 15, 2018 by ark

[Wink207 78]

16 minutes ago, ark said:

Rick,

You are correct, same here, the heading bug does not work now even though it did before. Something must of happened with the latest install package. I'm sure it will get fixed in the next update.

BTW, there is no yoke heading switch (there is a trim rocker switch on the Yoke). The heading and course adjustment knobs are on the center console just above the AP. Clicking on the HSI will bring up a similar looking popup.

Al

Thanks Al. Just normal Beta stuff.

[Flysimware 647]

Beta 2.5 had exported bad and the main panel had some issues. Should be fine after this version.