Falcon 50 - Cold and Dark in Menu Kills N2 Gauge

[scottb613 1,188]

Hi Folks,

Re: P3Dv4

If you select "All Systems Off" via the onscreen Falcon menu - the N2 gauges subsequently cease to work...

This affects both startup and after engine is running...

Regards,

Scott

Edited November 18, 2018 by scottb613

[ark 1,288]

28 minutes ago, scottb613 said:

Hi Folks,

Re: P3Dv4

If you select "All Systems Off" via the onscreen Falcon menu - the N2 gauges subsequently cease to work...

This affects both startup and after engine is running...

Regards,

Scott

All systems off disconnects the C and D buses from the A and B main buses. I think they need to be reconnected (such as by Ready to Start, etc, for the engine gauges to work.

Al

[scottb613 1,188]

2 minutes ago, ark said:

All systems off disconnects the C and D buses from the A and B main buses. I think they need to be reconnected (such as by Ready to Start, etc, for the engine gauges to work.

Al

Hi Al,

I'll try moving the C and D bus switches to see if that makes a difference... Think only the N2 gauge was affected - others looked normal to me...

Thanks...

Regards,
Scott

[scottb613 1,188]

11 minutes ago, ark said:

All systems off disconnects the C and D buses from the A and B main buses. I think they need to be reconnected (such as by Ready to Start, etc, for the engine gauges to work.

Al

Hi Al,

Confirmed - my C and D ties were in the wrong position - operator error - thanks so much - this is closed for me....

Regards,
Scott