TCAS Question

[Wink207 78]

Hi all:

I have been working with the Falcon, downloaded Version 3.1 today, and flew KPBI-KBOS. All went well and I must comment on some great things about the Falcon from an FSX pilot perspective:

1. Great frame rates

2. Minimal VAS hit

3. A beautiful aircraft, inside and out.

I am looking forward to many hours in the air with this aircraft, as I did and continue to do with the Lear 35. The Falcon fills a hole I needed for a longer range bizjet.

One question I have in 3.1 is something I noticed with the TCAS. As I departed the PBI terminal area there was lots of traffic, and one aircraft close enough to trigger a TCAS alert. At that point it seemed that the TCAS locked up somehow, the display turned red, and would not respond to attempts to change the range as I flew up the coast to Boston. The control was set on TA/RA.Could someone advise me as to my error in procedure, or is there an issue here.

Thanks

Rick

Edited November 19, 2018 by Wink207

[Flysimware 647]

Never seen red screen during the entire development of the code. Keep us posted if it continues to happen.

And very happy with your other comments as i hope users will enjoy this bird!

[ark 1,288]

2 hours ago, Wink207 said:

Hi all:

I have been working with the Falcon, downloaded Version 3.1 today, and flew KPBI-KBOS. All went well and I must comment on some great things about the Falcon from an FSX pilot perspective:

1. Great frame rates

2. Minimal VAS hit

3. A beautiful aircraft, inside and out.

I am looking forward to many hours in the air with this aircraft, as I did and continue to do with the Lear 35. The Falcon fills a hole I needed for a longer range bizjet.

One question I have in 3.1 is something I noticed with the TCAS. As I departed the PBI terminal area there was lots of traffic, and one aircraft close enough to trigger a TCAS alert. At that point it seemed that the TCAS locked up somehow, the display turned red, and would not respond to attempts to change the range as I flew up the coast to Boston. The control was set on TA/RA.Could someone advise me as to my error in procedure, or is there an issue here.

Thanks

Rick

Rick,

There is only one TCAS range implemented.

Al

 

 

Edited November 20, 2018 by ark