QW 787 crashing before P3D start loading the scenario.

[Pilotamatyi01 0]

Hello.

Firstly I say sorry becuse my english is really bad. Some day ago i was bought a new computer which spec is: i5-3570, 8GB ddr3, AMD HD7790 (1GB gddr). When I select the QW 787 in the aircraft selector loading without problems. But when I press Start the flight, the P3D v4.3 crashing without any message. You can read the ContentError Log here ( https://pastebin.com/ejpfAwsJ )  I was tried to reinstall the 787 two times but nothing changed. Can anybody help me what problem couse this?

Thanks for your answers and Happy Holidays! :)

[Jim Young 2,356]

When you load a scenario, P3D mostly loads scenery you selected during the setup as the QW787 was already loaded successfully (as you stated).  What was the percentage of loading when the sim crashed?  That will give a clue.

[Pilotamatyi01 0]

Sometimes 0%, sometimes 82%, I heard about the 82% is a critics point of the loading.

[Jim Young 2,356]

Well, at least you can discount that the QW 787 was causing your crash.  At 0% nothing is loading.  Normally, the loading will stop at 6% and hang there for a few minutes if you have a lot of photo scenery.  At 82% I believe the terrain, water, and skies are being loaded.  You can disable all of your add on scenery and see if this fixes the problem.  If it does then you will have to figure out which one caused it.  See the AVSIM CTD Guide around page 10 on how to fix most crashes and freezes in P3D.

[Pilotamatyi01 0]

Thanks! I will check out! 🙂