Instant acceleraton on default. Why?

[spilok 1,133]

Whenever I start P3d, my default plane (whatever it is) accelerates rapidly, and I have to throttle up and down quickly on my joystick.  This calms it down.  I've tried saving my default setup even in a "cold and dark" scenario, but as soon as I start the engines, it revs up....and thus requires a quick throttle up and down to calm it.

Does this happen to you when you start the sim?  If you have an answer for this, I would appreciate it greatly.  I just want to start the sim, and have a plane that is "un-reved".

 

Stan

[jabloomf1230 2,445]

Load the P3d4 default scenario with the default aircraft. Does this still happen? I

[newtie 533]

Are you running SimStarter? I had this behavior running the app and after removing it, all worked normally.

Cheers,

Mark

 

[spilok 1,133]

Actually using the Milviz 310 as default aircraft.  Didn't think I had to load a default aircraft in P3d.   Thought that was an FSX thing only.  Will try a default aircraft to see if it still happens.

 

Stan

[Guest]

Yeah, I've seen this behaviour too but if I recall correctly only with the A2A spitfire.

By the time I get it under control usually the aircraft is about 30 degrees of the runway center line. Very annoying!

[vgbaron 3,600]

12 minutes ago, spilok said:

Actually using the Milviz 310 as default aircraft.  Didn't think I had to load a default aircraft in P3d.   Thought that was an FSX thing only.  Will try a default aircraft to see if it still happens.

 

Stan

With the complexities of many new aircraft, it's a really good idea. Personally, I start with the default cub and have had no problems. Takes a few seconds to switch after loading and saves time in the long run.

Vic

[spilok 1,133]

Tried the default Maule and still had same problem.  Will continue with other aircraft.  Will try the cub.

 

Stan

[vgbaron 3,600]

Did you configure the 310 in MVAMS to load "cold & dark" ?

If it keeps happening, I'd look closely at your controller setups.

Vic

[newtie 533]

Uninstall and reinstall your throttle controller.

[spilok 1,133]

Umm.  The controller itself.   That's an area I didn't look at.  Thanks.

 

Stan

[lennie 48]

I have the same problem, with most aircraft. Occasionally I don't have a problem, but almost always with the Grand Caravan. I haven't loaded the cub first but will try tomorrow. Glad to be part of this discussion!

[gpf3m 41]

This happens to me with all A2A aircraft.

[vgbaron 3,600]

This does happen in older turbo aircraft made for FSX. The Quest Kodiak comes to mind. There is/was a bug in the FSX logic that would affect certain turbo a/c. 

[D Nelson 23]

I am experiencing the engine acceleration also. It doesn't matter which aircraft, it occurs with all of them default or payware. Cycling through views "S" does this for a second or two.

Edited January 6, 2019 by D Nelson