Jump to content
Sign in to follow this  

VTOL issues with EZCA2

Recommended Posts

Hello people!

After long time I'm back on the forum, this time with an issue.

I recently bought Dino Cattaneo's F35 ABC package. I found an issue in the vertical take off. The Aircraft is like "glued" on the ground (it can taxi) also if the power setting is at maximum and the GW is less than the VTOL limit (40.6K lbs)

Changing the Aircraft view from inside to outside, and outside to inside will allow the Aircraft to take off like if the glue is immediatly removed. The same happens if I pause/unpause the flight, or open the ezca interface.

I know, you say "why do you think it is an EZCA problem?" 

It is because the

same behaviour is present on the MV-22 Osprey. The MV22 and the F35 have in common the same VTOL code made by Rob Barendreg. I know this because I already contacted Dino and Rob.

After a troubleshooting phase I found that disabling EZCA (disconnecting EZCA completely from simconnect) solved the problem (leaving me with more, no hat switch for views…).

As neither Dino, neither Rob are aware about other users with the combination EZCA/VTOL airplanes issues, I ask here...


Anyone with this issue?

Anyone found a solution to that?




Andrea Daviero


P3D V4.3



Andrea Daviero

Share this post

Link to post

Update on this issue:

I've updated Ezca to ezdock 3... Now the hovering problem is a very BIG problem...

Previously it was working with just the little bug I described. Now, with EZDOCK 3 no hovering is possible. When I select it it will not slow down the airplane and after some seconds it stalls with no apparent reason.

F35 B is no more usable in VTOL configuration. I need to check the V22.


Andrea Daviero

Share this post

Link to post

Are there any other people out there having problems with EZDOCK in combination with any of my VSTOL codings (like in Dino's F35B or Maryadi's MV22B Osprey) ??
If so. please reply.
Also, I would like to know too if other people have this combo working without problems.

As I explained to Andrew, the most likely cause is some kind of interworking conflict between two independant applications both using SimConnect to read/overwrite variables.


Share this post

Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
  • Tom Allensworth,
    Founder of AVSIM Online

  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Create New...