Need LINDA support

[Drye 0]

Hello,
I have been a fan of Linda for many years.
I installed P3Dv4.4 and Linda3.0.9.
I would like you to help me solve the problem that I encounter since this new installation.
1 / If I run P3Dv4, opening linda does not happen automatically. When P3Dv4 is open I am forced to open Linda manually, which does not find the way. G: \ Prepar3Dv4 \ Modules \ Linda / System / init.lua, while the file exists.
The same applies to: "Saving_auto_777.lua, and 777com.lua"
2 / If I first run Lua and then I run P3Dv4, everything opens normally, but I do the preparation of the PMDG 777-200 until the Pushback and nothing has registered in the console Linda.
I am using FSUIPC5.5.15
Thank you for your help because I am a little lost.
Cordially.
Alain Drye

 

[guenseli 1,577]

Hello,

 

I split your post, because it has nothing to do with the GSX library. Please take care about.

 

Have you set LINDA to start GUI with sim in the LINDA setup?

 

Point 2 I do not really understand, plase try to explain in an other way

thanks

[Drye 0]

Hello,

I send you FSUIPC.doc, following a launch of P3Dv4 and Linda that I launched manually.

Cordially.

Edited February 16, 2019 by ScotFlieger
Pasted log removed

[ScotFlieger 280]

16 hours ago, Drye said:

following a launch of P3Dv4 and Linda that I launched manually.

For us to understand your problem, please follow the fault diagnosis procedure and email us the logs - do not cut and paste.