How to stop AI's from using a particular runway

[unc1rlm 30]

I have FlyTampa VHHX v2 for p3dv4. I have 747's not clearing the mountains heading north from Runway 31. Does anyone know which afcad to edit to close Runway31. Just curious.

Unless you know a FDE for the 747's that will enable them to clear the mountains. I know that I can set the weather in p3dv4..the winds from say 320 at 16 kts trying o get them up and over.

Great scenery.just need a little tweak.

 

Warmest and Bestest,

BobM..

[Dave_YVR 968]

You can just edit it with ADE. Double click on the runway and select Yes or NO for Landing or Takeoff.

[unc1rlm 30]

The problem is I can't find the right bgl file. I looked in the default airport (P3dv4) and RWY 31 has yellow X and I believe it says under primary Landing/Taxi NO but in the Fly Tampa scenery folder i don't see the bgl....there is a cvx file but ADE won't open it. So thats where I am at Dave.

https://imgur.com/ayNSZd9              Top section of Scenery folder 

 

https://imgur.com/rbJBPho                 Bottom section of Scenery Folder

 

Thank you,

BobM.

Edited April 9, 2019 by unc1rlm

[Dave_YVR 968]

 Well, of course, it isn't going to be in the default airports. It will be in your FlyTampa VHHH scenery folder and not the cvx file (those are for airport boundaries and landclass and stuff like that etc). It's the VHHX_nostatic_adep4_flytampa.bgl.

Edited April 10, 2019 by Dave_YVR

[unc1rlm 30]

Well thank you Dave.....looking every where, even under the kitchen table 🙂

Bestest,

BobM.