Jump to content

Sign in to follow this  
Blaze

QW 787 Flap Axis Control using FSUIPC

Recommended Posts

Hello, I recently purchased the QW's 787 but I am having a difficult time programming the flap axis control using the registered version of FSUIPC  that I am familiar with. I did a search and didn't find much so it's probably on my end but I have not found the culprit yet. The issue I am having is if I assign the flap axis to FSUIPC and calibrate that axis accordingly it ends up being an all or nothing affair.

In other words if I assign the flap axis to lever on my Saitek Throttle or GF TQ6 and then cycle it through it's range of motion the flap lever in the virtual cockpit will not move at first  but,  you can hear it cycling through the steps/settings, once my hardware lever reaches the top or bottom of its range, then all of a sudden the VC flap lever will move to that limit either fully retracted or fully extended but it will not stop at any of the steps/settings in between.

I'm running the latest version of QW787 available from Flight One.

Curious if anyone else, have a similar occurrence?


RE Thomason Jr.

 

 

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  
×
×
  • Create New...