Non-Sequential Layer order detected

[unc1rlm 31]

Non-Sequential Layer order detected

137,136,135

should be corrected

I looked in the scenery cfg and everything is ok where these are at the bottom.

How do I fix it because it may be why Voxatc won't index..stops at weather\themes

I have v1.40b04 installed

P3dv4.5

 

Thank you!!

BobM.

Edited April 27, 2019 by unc1rlm

[Lorby_SI 2,038]

7 minutes ago, unc1rlm said:

Non-Sequential Layer order detected

137,136,135

should be corrected

I looked in the scenery cfg and everything is ok where these are at the bottom.

How do I fix it because it may be why Voxatc won't index..stops at weather\themes

I have v1.40b04 installed

P3dv4.5

 

Thank you!!

BobM.

Hello Bob,

that is probably a conflict with an add-on.xml

• I suggest that you update to the latest version b06.
• then create a backup of your config files on the tab "Backup/Restore"
• Now turn on auto layering if it isn't active already
• Move each of the offending sceneries up one step and down again.
• Check if the layers are correct in the list before saving

I have this too from time to time, but moving the sceneries around with the up/down buttons usually fixes it.

If it doesn't, and you get stuck, please send the ZIP that you created in step 2 to me by email. Address is on the last page of the manual.

Best regards

Edited April 27, 2019 by Lorby_SI

[unc1rlm 31]

shouldn't I backup before I install the new version? maybe not :) would save the offending stuff too.

BobM.

Edited April 27, 2019 by unc1rlm

[Lorby_SI 2,038]

1 minute ago, unc1rlm said:

shouldn't I backup before I install the new version?

BobM.

If you want - but that isn't really necessary. Just try to conserve the state where you have the error, just in case.

Best regards

[unc1rlm 31]

Thanks

 

BobM.

Edited April 27, 2019 by unc1rlm