Jump to content

furger

Remote overhead panel 777, no button/switches showing

Recommended Posts

Hi Mark

I am facing a problem with the remote overhead panel for the 777 i.e.

- license is showing ok

- overhead client (OverheadClient.exe) is running fine (running on the PC where Prepare3D is installed)

However, when opening the given http address for the overhead panel on my iPad, just a blank sreen is disclosed (verified on two different remote devices [both running iOS]). When clicking anywhere on this blank screen then the ovehead tableau is showing. But there are no buttons, switches, etc. SimServer is also dislcosing "Connected Devices: 0". CDUs are running fine on the same device. Restart of SimServer does not help.

Any idea what I should check?

Thank you for the support.

Best regards

Andreas

Share this post


Link to post
Share on other sites

Hi Mark

I just realised that when I doubleclick on the non-functional overhead panel (intended zoom) I end up with the following error message.

4a020ee19e64057b265a6968caed3018-full.jp

Above probably might help you in analysing the problem I am facing . . .

Share this post


Link to post
Share on other sites
22 minutes ago, furger said:

Hi Mark

I just realised that when I doubleclick on the non-functional overhead panel (intended zoom) I end up with the following error message.

4a020ee19e64057b265a6968caed3018-full.jp

Above probably might help you in analysing the problem I am facing . . .

Hi Andreas,

which browser are you using?

Share this post


Link to post
Share on other sites

Hi Mark

In the iPad I have tried unsuccessfully with both Safari and Firefox.

Share this post


Link to post
Share on other sites
3 hours ago, furger said:

Hi Mark

In the iPad I have tried unsuccessfully with both Safari and Firefox.

Ok can you please send me your logfile via email after you connect via Safari?

Share this post


Link to post
Share on other sites

Ok, so the issue here was that the browser used was simply too old.

I've added a sanity check that shows a corresponding warning.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...