GSX L2 floating jetways?

[avi8tir 25]

flew out of KCRW yesterday and the jetways were about 50ft above the terminal. Everything else at the airport was fine. any ideas?

[Skiff 9]

Go into the GSX settings for the airport and click the small airplane icon. That will align the jetways to the airports elevation. 

[pete_auau 1,158]

if  you  got  orbx   vectors  you need  to run  the  vector  tool  or  exclude it

[Kilo60 660]

Had had to do both suggestions and got it resolved on my end!

[avi8tir 25]

On 10/2/2019 at 10:05 PM, Skiff said:

Go into the GSX settings for the airport and click the small airplane icon. That will align the jetways to the airports elevation. 

Where is this located? I cannot find it in the GSX settings.

[747 Fan 11]

Go to the GSX "Customise Airport" page.

In the upper right hand corner you'll find a little plane and some elevation values.

Mark all the air-bridges on the right of the panel and click on the little plan.

That should set it right