Jump to content

Sign in to follow this  
nisx

CRJ Professional Released

Recommended Posts

From what I can tell from the information released about this CRJ Professional....P3d v4.5 is required....in other words, it will not function properly if you are running P3d v4.4.....or am I missing something here?

Share this post


Link to post
Share on other sites

For $80 I think I'll pass.  The cost of some of these payware planes is getting absurd.

Dave

Share this post


Link to post
Share on other sites
2 hours ago, p3dnerd said:

From what I can tell from the information released about this CRJ Professional....P3d v4.5 is required....in other words, it will not function properly if you are running P3d v4.4.....or am I missing something here?

I don't think that this is open to interpretation.

Quote

System requirements:
Lockheed Martin Prepar3D V4.5 

I would agree that it is not cheap.

Perhaps they picked the mid point between 700 and 900, it's been done before.

Share this post


Link to post
Share on other sites

There's a discount for those who already own the first version. I installed it an did a short flight this morning, I think they've done a great job with it. I'm usually critical of aerosoft, but I have to hand it to them on this one. 


i7-7700K | GTX 1080 | Asus TUF Mark I | G.Skill Trident Z DDR4 16GB | Samsung 960 M.2 Evo 1 TB | Corsair H105 | EVGA 850 | NZXT H440

Share this post


Link to post
Share on other sites
33 minutes ago, Reader said:

I don't think that this is open to interpretation.

I disagree. Since testing and verification is primarily conducted on the latest available sim release, it's quite typical to state that is a requirement, even if it would work fine on an older one.

I'm curious about P3D V4.4 operation myself. 

Edited by odourboy

7700K@4.8 GHz - MSI Z270-A Pro - 4x8Gb Corsair Vengeance DDR4 @3000 MHz - ZOTAC GTX 1080 TI @1683 MHz - 58" Panasonic TC-58AX800U 4K - Saitek X-55 'Rhino', ProFlight Pedals - TrackIR 5 - W10 Home 64 - P3D v4 - XP11

Share this post


Link to post
Share on other sites
32 minutes ago, nisx said:

There's a discount for those who already own the first version. I installed it an did a short flight this morning, I think they've done a great job with it. I'm usually critical of aerosoft, but I have to hand it to them on this one. 

How's the performance compared to the first release (particularly stuttering)?

  • Upvote 1

7700K@4.8 GHz - MSI Z270-A Pro - 4x8Gb Corsair Vengeance DDR4 @3000 MHz - ZOTAC GTX 1080 TI @1683 MHz - 58" Panasonic TC-58AX800U 4K - Saitek X-55 'Rhino', ProFlight Pedals - TrackIR 5 - W10 Home 64 - P3D v4 - XP11

Share this post


Link to post
Share on other sites
47 minutes ago, nisx said:

There's a discount for those who already own the first version. I installed it an did a short flight this morning, I think they've done a great job with it. I'm usually critical of aerosoft, but I have to hand it to them on this one. 

Just bought, agree.

  • Like 1

Rick Almeida

Share this post


Link to post
Share on other sites

While being able to install it in v4.4, could not get it to load. Switching the OH battery switch on, nothing powers up.

  • Upvote 1

Rick Almeida

Share this post


Link to post
Share on other sites
5 minutes ago, vc10man said:

While being able to install it in v4.4, could not get it to load. Switching the OH battery switch on, nothing powers up.

Well that clears up that! Thanks.


7700K@4.8 GHz - MSI Z270-A Pro - 4x8Gb Corsair Vengeance DDR4 @3000 MHz - ZOTAC GTX 1080 TI @1683 MHz - 58" Panasonic TC-58AX800U 4K - Saitek X-55 'Rhino', ProFlight Pedals - TrackIR 5 - W10 Home 64 - P3D v4 - XP11

Share this post


Link to post
Share on other sites

If it was not written, I would not have believed it.

Now everyone who reads this can too.

Share this post


Link to post
Share on other sites
7 hours ago, odourboy said:

How's the performance compared to the first release (particularly stuttering)?

No stuttering for me. I was getting high 20s to low 30s on the ground, 35+ in the air. The only issue I found so far is a sequencing problem with the FMC. When I input the next desired waypoint, it goes, for some reason, to the point after the one I selected. I think there's a disparity between the legs page and the direct-to functionality. I think I had this issue with the prior version when it was released as well. 


i7-7700K | GTX 1080 | Asus TUF Mark I | G.Skill Trident Z DDR4 16GB | Samsung 960 M.2 Evo 1 TB | Corsair H105 | EVGA 850 | NZXT H440

Share this post


Link to post
Share on other sites

Quick update: had a CTD while on descent. Here were my conditions:

- Active Sky

- Rex Skyforce

- Rex Environment Force

- Vpilot (vatsim)

- Chaseplane

* CTD occurred while zooming in on a STAR on the EFB *


i7-7700K | GTX 1080 | Asus TUF Mark I | G.Skill Trident Z DDR4 16GB | Samsung 960 M.2 Evo 1 TB | Corsair H105 | EVGA 850 | NZXT H440

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    28%
    $7,035.00 of $25,000.00 Donate Now
×
×
  • Create New...