Problem mit Voice Command Dome Light

[benne36 0]

Hello, Byran!

first of all thanks again for the new software of the PMDG NGXu.
But I found a small problem.

In the Voice SOP2 you can give the command "SET DOME LIGHT...".
Now the command doesn't exactly happen the way you give it.
I would like to describe it:
The switch is set to Off (middle). If you give the command "SET DOME LIGHT On", the switch goes to DIM (above).
But if you say the command "SET DOME LIGHT Off", the switch goes briefly to "Off" (middle) and then further to "BRT" (bottom). If you say "SET DOME LIGHT Off" again, nothing happens anymore. Only when you give command "SET DOME LIGHT On" again, the switch goes to "Off" as you wanted it with the command before.
I would be happy if you take a look at it.

Is it possible to program the switch with the command "Off, dim and brt" and the matching command?

Thank you
benne

[byork 2,258]

I'll check it for V1.1.  

Thanks for the report!