Nemeth Designs Kamov KA-32A Helix

[blaunarwal 432]

Nemeth Design published version 1.03

Changelog version 1.03:

- Front wheels turning direction
- Added touchdown sounds
- Added ground roll sound
 

They seem to have read my mail. 😉

[blaunarwal 432]

Since I had some problems to start the engines, here my short version

Overhead:

Batteries on, Inverter Manual

Middle Console
Start APU:
Open APU Valve, select start mode, use start switch, APU spools up.

Engine start
Open Fuel valve LH, Engine Control to IDLE, select LH, Select Start mode, use start switch, yellow light goes on.
Same for RH

Inverter to automatic

Has anyone understood the autopilot and the switches and buttons on the collective?

[kekelekou 42]

V1.04 is out!

https://forums.helisimmer.com/t/kamov-ka32a-v1-04/1213

« 

Update Version 1.04 has been released for the Kamov Ka-32. Most of the visual and animation errors have been fixed. Also, several switch tool-tips, sound effects and system functionalities have been changed/corrected too. Please check the installer info for the full list of fixes.

The installer in our store are patched to v1.04, so if you bought the Kamov in our store you can either download the entire new installer version from your account at the order history tab or download only the v1.01 to v1.04 updater from the product page. Those who purchased it from one of our partners can download and use the same updater.

Note that the Updater v1.04 from the product page requires at least the full v1.01 product pre-installed.« 

 

Impressive support from ND.

 

[blaunarwal 432]

1.04 is a bit tricky to find on the Nemeth pages. Interesting, they did not push this update to Simmarket like before. There´s still 1.03 on my download list. But I could install with the update file from Nemeth without  problem.

[Pere 1]

 

hi, is it possible to fly that helicopter in P3Dv4.3?, thanks

[Pere 1]

 

hi, is it possible to fly that helicopter in P3Dv4.3?, thanks

[Pere 1]

hello everyone I continue to have problems starting the engines, after getting cold and dark I start the list of procedures described in the file ka32_chk.htm, I can turn on the APU, but by selecting start on the left engine it does not start, I would like a possible solution, thank you very much