Linda PMDG 747 delay ?

[raam123 5]

Hi,

I have a 3-5 sec delay between order sent till it excuted...

Does anyone encountered the same ?

Edited April 1, 2020 by ScotFlieger

[ScotFlieger 280]

What functions are being delayed? Does this happen with other aircraft? 

I have seen this type of delay when errors occur in the code. Take a look at the LINDA Console log to see if you have any error lines marked in red.

[raam123 5]

42 minutes ago, ScotFlieger said:

What functions are being delayed? Does this happen with other aircraft? 

I have seen this type of delay when errors occur in the code. Take a look at the LINDA Console log to see if you have any error lines marked in red.

Will do !

Thank you.

[rob0203 686]

I had this also with 747 not with the Ngxu. Will check it again with Prepar3d V5. (Have v4 uninstalled now)

Like heading and altitude etc on my Mcp Combo

With me it was only sometimes, could be also USB power management issue then? 🤫

Edited April 17, 2020 by rob0203

[ScotFlieger 280]

LINDA 3.1.1 is not compatible with P3Dv5/FSUIPC6 and I am working on it.

On the power management issue I recently had to reapply all my USB power management fixes as I suspect a Win10 update reset them.

[rob0203 686]

Still have the delays (only with 747), do I need to setup power management?

Where do I find the hardware ID for the MCP combo? It is not in the joystick list in Linda.

Thanks for help,

Robert

 

[ScotFlieger 280]

Power management is only needed for power hungry Saitek/Logitech Panels.

The VRi Combo MCP panels do not have a HID ID. They use the ComPort and type set on the Setup MCP page. 

[rob0203 686]

Ok, still have the dials respond slow a lot of the time for speed, altitude etc. 

It is a PMDG 747 problem, 737 module is working flawless.

[ScotFlieger 280]

Please follow the Fault Diagnosis Procedure (under LINDA Support) and email me the logs. This will show me if there are any errors in the module. 

[rob0203 686]

Somehow I don't have the problem anymore, maybe since new version of Linda? I had a problem with dialing altitude down but found out that by accident I had assigned something to that in FSUIPC. So I am very happy now!