GTN750 flightplan not following by the plane.

[jopoloco 3]

Hello Simmers,

I have RealityXP GTN750 as software on my monitor. seeing the Airbus320 Professional. All is working and configured well.

When I make a plan with fill in the waypoints, then the plane do not follow the GTN750. All data can be seen and to use, but the small plane in the display goes only right on after take off.

My opinion, no connection with my plane . At the end of the a config panel I have clicked on "Restore Airbus Aerosoft etc."

So, all is working but no navigation. It can be that I made a mistake or forgot to do a thing.

Hoping for a solution.

 

With regards

 

Jopoloco

[Freo 83]

Pretty basic question, but are you sure that you have it in GPS mode and not VLOC ?

[Bert Pieke 7,584]

A GTN does not steer an Airbus... it uses an FMC for autopilot input.

Try a GA airplane, and if problems, post in the RXP GTN support forum