Hi,

i need help regarding Linda and FsLabs. I have installed P3D 4.5 HF3 and the latest Linda and FSLabs Airbus. FSUIPC 5.153 is registered.

My FCU Combo is recognized by LINDA. Also my Joysticks and Buttons. I assign Buttons and click on save. Linda is restarting the module and everything seems fine.

But the FCU Combo doesn´t trigger an action inside the Airbus in the VC. I have no more ideas, what could be the problem.

Any suggestions/ideas. Thank you for your help in advance.

Kind regards

Tasso

Hi Tasso

Do you have the latest LINDA FSLabs module installed along with its FSLABS-MAIN.MCRO is the /modules folder? What version of the FCU Combo are you using?

I would ask you to follow the Fault Diagnosis Procedure thread and email me your logs together with the config-mcpX.lua file (/modules/Linda-cfg/aircrafts/FSLabs A3XX). Read the instructions carefully.

Hi Scot,

thank you for your answer. Yes, all present versions installed. Linda 3.11 and Fslabs module 1.4. I haven't this file in the folder called config-mcpx.lua

 

 

The config-mcpX.lua is saved when you save your MCP assignments. The X refers to the model of FCU which you have not mentioned. Have you enabled the MCP Combo in Setup MCP Combo page? 

I need to see the logs to advise you further.

I found the problem. It was my fault at the end, i configured the wrong com-port in fsuipc.

Thank you very much for your quick responses. 

You are very welcome.

LINDA should write the correct ComPort details at the press of a button (Setup MCP Combo / Make changes for you?).

Enjoy.