[solved] EZCA 3 Problem with V5

[dyl55 21]

Hey

Does anyone had success with Ezca camera in v5 ? If I "click" on the caméra in main ezca panel everything good but as soon as I use my yoke command to switch view it switch to view that doesnt even exist, change my zoom setting,...

Same when I switch catégories it goes outside view and then switch between outside and tower but never go back on the inside view

Any idea ?

SOLVED HERE'S THE SOLUTION IN CASE

I had to delete every view key assignement in p3d AND ezca and then remap them 

Thanks 

Edited May 17, 2020 by dyl55

[Nickbe 401]

Hi!

Also note that for the EZCA v3.1 VC mouse view worked correctly, you must disable the "Enable advanced mouse control" option in Prepar3Dv5.