CameraPosition zoom question

[Leclercq A. 44]

Hi Oliver

I use p3dv4.5 last HFix

CPX run in administrator mode.

In CPX, I can set the eyepoint to current position, but not the zoom value

I'm in VCockpit with zoom to 0.70 as writed in manual. I synchronise CPX by Adjust value of the zoom to correspond with the zoom value of P3D

I set the zoom in CPX with button out to 0.55. The zoom change also in p3d.

When I click the button Set default eyepoint to current position, the zoom value return to 0.30. Can't load the aircraft with the fixed 0.55 value I want.

Where is my mystake? Can you help me ?

Regards 

Aimé

Edited June 20, 2020 by Leclercq A.

[Lorby_SI 2,036]

Hello Aimé,

that sounds like a bug.

But I am not entirely sure that what you are trying to do will even work with the current code, a change may be required. Would you mind sending me an email with specifics about what you expect to happen? The address is on the last page of the manual. 

Best regards

Edited June 20, 2020 by Lorby_SI