Aerosoft CRJ Available for P3D v5

[JasonPC 173]

11 minutes ago, Dreamflight767 said:

Is this update only for v5?

It's for both versions but there are separate installers.

[Dreamflight767 312]

5 hours ago, JasonPC said:

It's for both versions but there are separate installers.

Thanks.  Can't figure out why I can't find it.

[Shomron 251]

11 hours ago, Dreamflight767 said:

Is this update only for v5?

I remember them stating the fixes were general so I assume they went into v4 as well

[JRBarrett 3,049]

7 hours ago, Dreamflight767 said:

Thanks.  Can't figure out why I can't find it.

Where did you purchase it? Might want to post a note on the Aerosoft CRJ support forum. Perhaps they can give the vendor a nudge to get the installer updated.

If you purchased the aircraft directly from Aerosoft, the new installer will appear in your shop account immediately. They normally send out updated installers to their authorized resellers the same day they post it on their own system. In my experience SimMarket is usually very quick to update - not sure about other vendors.

[Dreamflight767 312]

Thanks everyone.  I am trying to resolve with the help of Aerosoft.  Issue appears to be with the vendor.  If no solution is reached, I'll share which vendor I used to help everyone avoid.

Thanks!  

[micstatic 4,316]

What performance are you guys getting in v5?  It’s my worst performer now. 

[Dreamflight767 312]

I was finally able to install latest build in v4.5 w/ all HF.  Airplane won’t stay on flight plan.  Drifted and flew way off course twice.  

[Prpn 366]

Sounds about par for the course with this addon, it's had LNAV issues from the very beginning 😅.

[Papa Golf 22]

2 hours ago, Dreamflight767 said:

I was finally able to install latest build in v4.5 w/ all HF.  Airplane won’t stay on flight plan.  Drifted and flew way off course twice.

You could try setting the Autopilot Disconnect Sensitivity to Low in the EFB options. It certainly stops issues where high winds can cause the AP to disconnect.

[cannow 61]

my biggest niggles the displays are blurry and EFB too dark ad dusk dawn. Even with the light textures cockpit too dark and not good on FPS

[micstatic 4,316]

Yep. It’s fine until I turn the battery on then my locked 30 will stutter a little 

[Dreamflight767 312]

2 hours ago, retepnodrog said:

You could try setting the Autopilot Disconnect Sensitivity to Low in the EFB options. It certainly stops issues where high winds can cause the AP to disconnect.

Thanks.  But from my understanding, that setting is only if you move the yoke.  I didn't see one for sensitivity in itself.

[Papa Golf 22]

3 hours ago, Dreamflight767 said:

Thanks.  But from my understanding, that setting is only if you move the yoke.  I didn't see one for sensitivity in itself.

I thought the same, but reading the Aerosoft forums, the recommendation for AP disconnecting due to wind gusts, etc. was to set the sensitivity to low and since I've done that, the CRJ rarely strays off course.

[GEKtheReaper 364]

21 hours ago, Dreamflight767 said:

I was finally able to install latest build in v4.5 w/ all HF.  Airplane won’t stay on flight plan.  Drifted and flew way off course twice.  

 

18 hours ago, Prpn said:

Sounds about par for the course with this addon, it's had LNAV issues from the very beginning 😅.

I was also in the beta and the CRJ surely received some improvements.

It is still a bit bad in performance and it somethimes does indeed do some strange turns but the best way to adress this issues is if you would give more informations about the situation encountered e.g: which CRJ, what livery, AIRAC, FPLN, etc....maybe also a short recording of the "error"... so that others (as me e.g.) can try to reproduce it.

[TurboKen 221]

It's harder on FPS and a steeper learning curve then say the QW787. But its still a joy to fly. I would recommend it, but only if you have a 1080ti or above v-card. Flight dynamics, sound set and visuals are all great in my opinion.

Edited July 6, 2020 by TurboKen