Cessna trim wheel , recognized , but cannot assign it

[motoadve 49]

Its recognized under the controllers, but when I try to assign it to elevator trim , I moved and nothing happens, so at the end cannot make it to work.

[CFIJose 5,485]

13 minutes ago, motoadve said:

Its recognized under the controllers, but when I try to assign it to elevator trim , I moved and nothing happens, so at the end cannot make it to work.

It could be that some controllers are not fully supported yet. Is there a sensitivity setting for the trim wheel? If so, it could give you a clue of what you need to delete in order to properly assign the wheel to trim up and down.

[J0nx 48]

It’s a very unintuitive interface. I had the same problem. You have to assign it to the trim axis and not the elevator trim. 

[motoadve 49]

11 minutes ago, J0nx said:

It’s a very unintuitive interface. I had the same problem. You have to assign it to the trim axis and not the elevator trim. 

Thanks

[Chairflyer73 8]

Mine works fine. 

I have to spin it everytime after boot up until you hear the windows USB sound and then start the sim.  The same as FSX/P3D and even X- plane.

There is no true axis,  it'll spin forever, so it needs "waking up" before you start the sim.

Also set it before takeoff or it'll try and kill you!

At least,  this is how it has always been for me.