Trees and buildings on the runway

[jmrtlara 15]

As I'm doing more flights recently at default V5 airports, I'm noticing that some airports have weird autogen issues where trees and buildings are all over the runway.

I have ORBX Base, Vector, Trees HD, Terraflora V2, and Buildings HD installed. I already tried verifying the ORBX Libraries to no avail. Even tried the Sync Simulator, no luck either.

Any ideas? I'm curious if this is a P3D issue or an ORBX issue.

[rickgo 64]

Can you name 2 airports where these conditiions exist? 

[jfmitch 33]

You might try the following entries in Prepsr3D.cfg  (Copy and paste)

 SmallPartRejectRadius=4 

 IMAGE_PIXELS_FOR_AUTOGEN_POLYGONS=128 

 

 

[jmrtlara 15]

10 hours ago, rickgo said:

Can you name 2 airports where these conditiions exist? 

They're:

RPVR and RPVD. Both default. It would be much appreciated if you can confirm that the issue also exist in your installation. 🙂

 

[rickgo 64]

Mine are totally clean. I use ftx global , dont have the other addons. I also dont use vector. I would head over to orbx forum if you dont find resolution here.

[jmrtlara 15]

2 hours ago, rickgo said:

Mine are totally clean. I use ftx global , dont have the other addons. I also dont use vector. I would head over to orbx forum if you dont find resolution here.

Ruling out a P3D issue then. I will try disabling Vector too.

Thank 

Edit: I disabled Vector using P3DAO and it instantly resolved the issues. I will report to ORBX.

Edited September 16, 2020 by jmrtlara

[OzWhitey 3,353]

10 hours ago, jmrtlara said:

Ruling out a P3D issue then. I will try disabling Vector too.

Thank 

Edit: I disabled Vector using P3DAO and it instantly resolved the issues. I will report to ORBX.

I would avoid vector in v5. Not needed, and may cause issues.