PF3 and P3d MSFS

[charlie130 196]

Has anyone managed to get PF3 working with P3d or MSFS?

Yes!! I know its not for MSFS yet?...so they say?

But we can use P3d data if we want to?

All I get is a borked install after I take off.

The PF3 just goes dumb?

its like it looses my position?

PF3 doesnt know where I am, it doesnt have any hotkeys that work?

In short, Im frustrated?

Has anyone got the latest PF3 working?

Or is my PC rubbish?

Thanks

 

[starter 8]

I'm on 4.5 hf2. For me it's working.

Had to change the hotkeys to a 1 single digit. (e.g. control shift 1 to 1). This way mce works without problems.

The few problems i have with pf3 is the 250 speed nag when asking for higher altitude, Think it was below 18000ft. en sometimes the freq change which got lost or i didn't get somehow.

Sometimes fo makes a misdial, so you have to check the freq if they are correct.

With latest 2 versions of mce it looks like if it freezes after done 1 flow. Didn't get no more response!!

In pf3 i'm in cp mode 0. When i started to use pf3, i started in cp mode 4 (where cp does do the job).

1. ask for atc clearance (make sure you get readback). (or press zero)

2. ask for start clearance. (or press zero).

3. ask fot taxi clearance. (or press zero), if repeated correctly i see a line saying tgs is activated, Deactivating is pressing 1

4. at holding point ask for takeoff clearance. (or press 6).

I used sid's (have that ticket) and sometimes i don't get "resume own navigation", then i ask for a "direct to" so he knows my position!

This is my experience and how i use it.

 

What do you mean by "borked install and goes dumb"? (sorry, english is not my native language!).

 

MSFS i have no idea. Don't have it.

Best regards,

John

 

 

Edited November 4, 2020 by starter

[BerndB 349]

Same here, works perfect for me as John discribed.