Honeycomb bravo throttle quadrant landing gear problem

[kpop1364 2]

I just received a bravo throttle quadrant. I installed the proper drivers.  This is for p3dv4.5. Everything is working perfect except for the landing gear. The led lights are on but I can’t raise the gear. I’ve activated the profile but still the gear won’t go up or down. What am I missing?  Any suggestions would be appreciated. This is very frustrating. 
Thanks, Gerry

[yvesamuel 17]

Hi,

 

Have you tried configuring with FSUIPC.

I allways ues it, it's so nice and easy.

Yves

[kpop1364 2]

Thanks I’ll give it a try. 

[kpop1364 2]

Everything else is working.  This should be working too. 

[gaab 111]

Have you desactivated the default assignements made by Prepar3D for a new equipment ?
They may conflict with the Profile configuration.

I had the case where a switch was making TWO actions...

The configurator will take care of that for you.

Gérard

[kpop1364 2]

FSUIPC didn’t work. The problem is it’s not recognized. I’ve installed and reinstalled the drivers without any success. 

[kpop1364 2]

I’ve tried disabling simulator defaults. That didn’t work either. 

[gaab 111]

Have you the Add-ons Honeycomn entry in P3D ?

Screenshoot extracted from "Basic test of the Honeycomb Bravo Throttle under P3D with the Honeycomb Configurator"

Gérard

[kpop1364 2]

I’ll check. 
By the way, I’m Gerald. Close!

[kpop1364 2]

Ok. A step forward. The led lights came on when I clicked on the BEF. Should be all green.  Have one orange light. But still the gear itself does not work. 
 

[kpop1364 2]

SB BFC. You know what I meant. 

Thanks

[kpop1364 2]

It seem that the gear lever is not activating.  I’ve checked it out with Windows game calibration. 
Thanks, Gerry