Info RivaTuner will not show : issues

[GSalden 4,655]

To finetune my system I have installed  Afterbuner (4.6.2.15745) and RTSS (7.3.0 beta 10) and set them up so I can monitor :

- the 14 cores loads

- GPU load

- min/max/avg FPS

However, when starting P3Dv5 a DXGI ERROR ACCESS DENIED message appears :https://www.dropbox.com/s/j62gb20ex67be2f/Foto 21-02-2021 10 12 23.jpg?dl=0

If I click Cancel and P3Dv5 has loaded I see a black screen https://www.dropbox.com/s/ifv5w4g9fv5ovg7/Foto 21-02-2021 10 14 30.jpg?dl=0

I have also tried with running RTSS after P3Dv5 has been loaded but then there is no contact https://www.dropbox.com/s/ajq6np1jz6lxp25/Foto 21-02-2021 10 08 14.heic?dl=0

Anyone can tell me what I am doing wrong ?

Thanks, Gerard

[Nemo 1,305]

On your third picture I'm seeing that you don't have a P3D specific profile. Maybe that's important? I have a related setup and in my case MSIAB/RTSS is running fine but I'm using MSIAB v4.6.3 b5. I guess you've read the RTSS thread on the next side.

[GSalden 4,655]

1 minute ago, Nemo said:

On your third picture I'm seeing that you don't have a P3D specific profile. Maybe that's important? I have a related setup and in my case MSIAB/RTSS is running fine but I'm using MSIAB v4.6.3 b5. I guess you've read the RTSS thread on the next side.

Unfortunately a P3D profile did not make any difference.

Also I found a topic that advised to set Water to lower than Ultra to make the text appear. But no difference either.

Thanks 😊 

[zementa 0]

After letting P3d creating a new cfg(p3d.cfg)File, it is working for me again. Maybe that will work for you too. 

 

[GSalden 4,655]

9 minutes ago, zementa said:

After letting P3d creating a new cfg(p3d.cfg)File, it is working for me again. Maybe that will work for you too. 

 

Thanks , will try that.

[Nemo 1,305]

2 hours ago, GSalden said:

Unfortunately a P3D profile did not make any difference.

Also I found a topic that advised to set Water to lower than Ultra to make the text appear. But no difference either.

Thanks 😊 

Did you try the latest MSI AB beta version as I suggested?

Edited February 21, 2021 by Nemo

[GSalden 4,655]

22 minutes ago, Nemo said:

Did you try the latest MSI AB beta version as I suggested?

Yes. After deleting the P3D.cfg file it worked once.. I now have uninstalled both.

HW Monitor shows the values too although not in P3D.

Thank you all 👍