Aerosoft Heathrow and A320

[Gaz 15]

I was taxing in the airport TO the runway, like i usually do, but for some reason it came up CRASH. Is there somewhere I can see where that would CRASH be located in a log so I can see why?

Gaz

[cyyzrwy24 127]

33 minutes ago, Gary McCluskey said:

it came up CRASH

CRASH meaning...? CTD or crashed into something at the APT? Did you uncheck " IGNORE CRASH" in P3D settings?

[Gaz 15]

No, I haven't set the IGNORE CRASH. Don't aircraft on the tarmac just go through if you set that?

I'll try it again given what you're saying.

Thanks

[cyyzrwy24 127]

1 hour ago, Gary McCluskey said:

I'll try it again given what you're saying.

Well,,,all depends on your (AI) traffic set up. Also bear in mind that even if you "call" APU and if is not set up properly it might "hit" airplane and you crash as well...or luggage train passing or fuel truck coming and turning near wing. Quite a few things are not realistically set. Unless you want to re-start everything every time I am suggesting to uncheck IGNORE CRASH.

[Gaz 15]

I agree. I'm going to take a good look at it tomorrow.

Thanks, Gaz