Jump to content
Sign in to follow this  
C2615

Ground crew not waiting long enough to wave off.

Recommended Posts

As our company's SOP(on 737, but similar cross all fleet),  after both engine was stable, we will call off disconnect and hand signal, then after that, we can start the before taxi(or after start) procedure.

After that, then we will call for ATC for taxi clearance, after then, it's finally the time to check the pin and wave off ground crews.

But currently in UGCX, ground crwe only wave it's pin for like 20 seconds, when I finally finished my procedure and look out side, they are long gone....

Could it be set longer? or better like wait until we set parking brakes off before they head back to ramp? as our procedure they must wait until the aircraft have  smoothly taxi out before they can head back to ramp.

Edited by C2615

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...