FSUIPC and elevator trim

[Pitter 23]

Hi,

can someone explain  me how to remove the "0" parameter within the "control send when button pressed".Field

If I delete them, and reopen FSUIPC, is back again.

The trim via a selected switch at my yoke does not work, maybe because of that "0".

But the FSUIPC.ini listed the switch for up/down

Tks, Peter

 

[ark 1,290]

10 hours ago, Pitter said:

Hi,

can someone explain  me how to remove the "0" parameter within the "control send when button pressed".Field

If I delete them, and reopen FSUIPC, is back again.

The trim via a selected switch at my yoke does not work, maybe because of that "0".

But the FSUIPC.ini listed the switch for up/down

 

 

It is not clear to me what control you are trying to use. It would be helpful if you would provide a screen shot of the FSUIPC Buttons and Switches assignment window that shows the control assignment for trim that you are trying to use.

Also see this thread in the MSFS Forum  -- the info also applies to P3D.

https://www.avsim.com/forums/topic/603428-elevator-trim-and-key-input-behavior/?tab=comments#comment-4572627

Al

Edited August 6, 2021 by ark

[Pitter 23]

Thanks for your quick answer.

Here is the link: https://drive.google.com/file/d/12pChuVZLNTP_EptQa7xkhJ3WvT9Pczom/view?usp=sharing

In the meantime I tried your above settings, but also with this no joy.

Peter

[Caveney737 66]

17 hours ago, Pitter said:

Hi,

can someone explain  me how to remove the "0" parameter within the "control send when button pressed".Field

If I delete them, and reopen FSUIPC, is back again.

The trim via a selected switch at my yoke does not work, maybe because of that "0".

But the FSUIPC.ini listed the switch for up/down

Tks, Peter

 

The zero shouldn't cause a problem, You need to tick the 'Control to repeat when held' box.

Hope this helps.

[Pitter 23]

Yes, it did help.

Thanks a lot for your tip.

Peter