FSStudio CYVR Runway 08R P3DV5.2

[DWadsworth 13]

Pilot2ATC is giving me a problem at FSStudio CYVR 1.11.  Having seleted 08R as departure runway, P2ATC taxi direction direct me to D7 for departure.  This is at the east end of the runway.  It should direct me to L, L2 or L4 for departure.  When I try to take off at any of the L departure points, P2ATC does not change to tower, and when I attempt to request TO clearance from tower, it switches me back to ground.  I have the most recent Navigraph, have run makerwys and have imported taxiways and gates.  All of my software is most recent.  I can provide the .txl file for CYVR.  

[Dave-Pilot2ATC 870]

Please email the txi file to me at Admin@pilot2aatc.com and I'll have a look.

Dave

[Dave-Pilot2ATC 870]

Thanks for the .txi file.

Looks like there's a missing TaxiPath on L just after L4 splits off.

I added in that taxi path and it started working correctly.

Dave

[DWadsworth 13]

Thank you.  I'm unsure on how to add that path, would you please point me to directions? 

[Dave_YVR 972]

 You can use ADE to connect the path. I believe it was done that way for better flow with AI traffic.

[Dave-Pilot2ATC 870]

If you use ADE, it will change it in the SIM and  then you would have to import the airport into P2A.

To import taxiways or to do maintenance on them for P2A, you use the Taxi Mnt screen in P2A.  

Instructions are in the P2A Operations Manual under Taxi Maintenance.

Dave

[DWadsworth 13]

Thanks - excellent support as usual!