Jump to content
Sign in to follow this  
Followers 0
jsmcwilliam

FS2Crew and EZCA

By jsmcwilliam, in FS2CREW: GENERAL FORUM

Recommended Posts

jsmcwilliam    3

jsmcwilliam
Posted

I run my Dash 8 Q400 with P3D v5.3 under windows 10. I also have the FS2Crew and EZCA addons.I have a problem when I get to the TakeOff Procedure in FS2Crew - the copilot readouts do not occur and I cannot communicate with FS2Crew until I get to the Climb Procedure.My solution for this has been to turn EZCA off during the TakeOff Procedure and turn it on again during the climb.This is the case at all airports and does noy apply to my other aircraft (PMDG 737 NGXu). There would thus appear to be a conflict between FS2Crew and EZCA during the TakeOff Proc. Does anyone have the same problem? Is there a solution?

John McWilliam

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0
Go To Topic Listing

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...