MSFS PMDG 737 and cockpit builders

[jetlag 65]

For many years i enjoyed my FS9 iFly 737 with home-made Arduino-based panels: overhead, MCP, EFIS, Nav/Com.  This was pretty easy thanks to the great iFly2FSUIPC interface.

All that went to waste when I switched to MSFS... until???  unless???

So, my question:  can somebody let me know if that brand new PMDG737 comes with a full complement of Lvars/Hvars which might allow me to put my hardware to good use again?

That would be great news!
Thanks,

Philippe

[nas123 160]

The new PMDG 737 for MSFS uses the same code base as the PMDG B737NGXu in P3D +a brand new exterior. So your old interface should work. You will need to enable datatransmission in the PMDG option file in the package's work folder. 

[jetlag 65]

Thanks for the good news. I had better learn a bit about LINDA, then.

[RobF2 150]

What about Mobiflight?

 

[STF-DIR 2]

Hello,

i have also a Homecockpit, but never with PMDG. But since Prosim is really worse in MSFS i want to change to PMDG.
I have SIOC, Pokeys and a Sismo Aft Overhead.

But i could not find a solution to bring the PFD/ND/EICAS and CDU Screens to my network PC's??

Is there a Solution available ?

Thanks
Matthias